CC3 Technical Information

Real-Time, 3-Color Compensation System

Absolute Maximum Ratings

(Operation above these ratings may permanently damage the CC3 system)

Input Signal Level

+/- 5 volts

Recommended Operating Conditions

(Best performance when operating within these conditions - Note 1)

Operating Characteristics

(Anticipated nominal performance when operating within the Recommended Operating Conditions identified above - Note 3)

Parameter	Value	Notes
Input Impedance (low setting)	50-ohms//100pF	4
Input Impedance (high setting)	1Meg-ohms//10pF	4
Input Coupling	DC or AC (0.1uF each leg)	5
Signal Bandwidth (-3dB)	6.5MHz	6
Uncompensated Signal Gain	1.0 V/V	2
Baseline Control	low-pass baseline restoration or offset control	7
Offset Control Range	+/- 1 volt	8
Offset Control Resolution	0.5mV (12-bit)	8
Factor Range	+/-200%	8
Factor Resolution	0.1% (12-bit)	8
Physical Dimensions	16.75"W x 3.5"H x 10.75"D	9
Weight	7 lbs.
Power Requirements	105-125VAC, 47-420Hz
Fuse	dual 3AG - 1A

Notes:

For research purposes only. Not intended for diagnostic or therapeutic procedures.
Output circuitry is optimized for driving 50-ohm coaxial cable that is properly terminated with a 50-ohm load. Due to a nominally 50-ohm output impedance, the output will be nearly 2x that expected if a high impedance termination is utilized.
The listed Operating Characteristics are typical values to be used for evaluation and are not intended to be guaranteed specifications. We reserve the right to change these values at any time without notice.
DC coupled.
Inputs are differential.
This signal bandwidth allows Gaussian pulses of >600nSec 1/e width to be processed without amplitude distortion.
For maximum performance, baseline restoration should not be used.
Referenced to input.
Separate handles provided for 19" rack mounting.